Connecting Rod Preparation Part 3

CONNECTING ROD PREPARATION: Part 3

Section A-A Section X-X Detail Z

O

0-7-degrees.

X

CROSS SECTION of Rod Cap.

P

0.93-inch Min. After contouring.

Y

Polish to remove sharp edges and machining imperfections in these areas prior to machining.

Q

Polish this area, both sides.

BB

T

Polish to remove sharp edges and machine imperfections in these areas prior to shot-peening

CC

Magnaflux 100%

DD

No. 1 center drill both ends. 0.07-inch typical depth

BOLT HARDNESS: Rockwell "C" 36-40

NUT HARDNESS: Rockwell "C" 28-34

O	0-7-degrees.	X	CROSS SECTION of Rod Cap.
P	0.93-inch Min. After contouring.	Y	Polish to remove sharp edges and machining imperfections in these areas prior to machining.
Q	Polish this area, both sides.	BB
T	Polish to remove sharp edges and machine imperfections in these areas prior to shot-peening