Connecting Rod Preparation Part 2

CONNECTING ROD PREPARATION: Part 2

Rod Prep

R

.0.945-0.944-inch.

V

Finish both crank and piston-pin diameters within these limits.

S

0.510-0.500-inch

W

Taper and out-of-round not to exceed 0.00015-inch when bolts are torqued to spec.

T

Polish to remove sharp edges and machine imperfections in these areas prior to shot-peening

Z

VIEW OF PIN HOLE.

U

Polish outer edge of these chamfers ONLY.

R	.0.945-0.944-inch.	V	Finish both crank and piston-pin diameters within these limits.
S	0.510-0.500-inch	W	Taper and out-of-round not to exceed 0.00015-inch when bolts are torqued to spec.
T	Polish to remove sharp edges and machine imperfections in these areas prior to shot-peening	Z	VIEW OF PIN HOLE.
U	Polish outer edge of these chamfers ONLY.